Submittal Sheet

FEATURES FOR RGLE-
■
The Comfort Control
2
System™ provides over 28 on-board diagnostics and
fault history codes by detecting system and electrical problems. “Call for
Service” alert notification is sent to the thermostat to alert the homeowner of
required service.
■
Serial Communication Enhanced – When installed with a Serial Communicating
Condensing Unit and user interface control ((-)HC-TST550CMMS) 500 Series
thermostat this unit offers 4 or 2 wire installation, auto-configuration, and
diagnostic messaging with full communicating capability.
■
Patented heat exchanger, constructed of both stainless and aluminized steel
for the maximum in corrosion resistance.
■
Low profile “34 inch” [864 mm] design is lighter and easier to handle, and
leaves room for optional equipment.
■
Energy efficient and quiet ECM 2+ communicating motor.
■
Improves cooling efficiency when matched with rated condensing unit and coil.
■
Constant CFM.
■
Seven segment LED for system diagnostics.
■
Diagnostic history for troubleshooting.
■
Dip switch settings for selectable cooling airflow.
■
On-demand dehumidification terminal for improved comfort in cooling mode.
■
Left or right side gas and electric inlet connections.
■
All models feature an integrated board with humidifier and electronic air cleaner
hookups.
■
Insulated blower compartment, a slow-open gas valve, specially designed draft
inducer motor and blower motor make it one of the quietest furnaces on the
market today.
■
Pre-paint galvanized steel cabinet.
■
Easy door removal and replacement.
■
Molded permanent filter.
■
Compatible with single or two-stage thermostat. (For optimal performance, two-
stage thermostat recommended.)
A variety of cooling coils and plenums designed to use with Super Quiet 80
™
Two
Stage Downflow gas furnaces are available as optional accessories.
✝A.F.U.E. (Annual Fuel Utilization Efficiency) calculated in accordance with Department of Energy test
procedures.
FIELD INSTALLED ACCESSORIES
Fossil Fuel Kit (RXPF-F01 and F02) ................................................................
Filter Rack (RXGF-CCM) ..................................................................................
Combustible Floor Base (RXGC-B17, 21, 24) ..................................................
Supply Air Sensor ..............................................................................................
Chimney Adapter: RXGW-B01 ..........................................................................
Thermostats ......................................................................................................
FORM NO. X33-1304
Supersedes Form No. X33-1304
SUBMITTAL SHEET FOR SUPER QUIET 80
™
TWO STAGE
COMMUNICATING DOWNFLOW GAS FURNACES EQUIPPED
WITH THE COMFORT CONTROL
2
SYSTEM
ECM Equipped Models with Input Rates from 75,000 to 125,000
BTU/HR [22 to 37 kW]
UNIT DATA
HEATING PERFORMANCE
TOTAL CAPACITY INPUT* ......
_______
MBH [kW]
TOTAL CAPACITY OUTPUT* ..
_______
MBH [kW]
DESIGN TEMP. RISE ..............
_______
°F [°C] DB
AFUE ................................................
_______
%
CALIFORNIA SEASONAL
EFFICIENCY ..................................
_______
%
(*uses blower motor heat)
SUPPLY AIR BLOWER PERFORMANCE
TOTAL AIR SUPPLY ................
_______
CFM [L/s]
TOTAL RESISTANCE EXTERNAL
TO UNIT......................................
_______
IWG
BLOWER SPEED ..........................
_______
RPM
POWER OUTPUT REQUIREMENT ..
_______
BHP
MOTOR RATING ........................
_______
HP [W]
POWER INPUT REQUIREMENT ........
_______
kW
ELECTRICAL DATA
POWER SUPPLY........................
___________ Hz
TOTAL UNIT AMPACITY................
_______
AMPS
MINIMUM WIRE SIZE ....................
_______
AWG
MAXIMUM OVERCURRENT DEVICE
FUSES/HACR BREAKER ..........
_______
AMPS
CLEARANCES
FRONT SIDE 3" [76.2 mm]
RIGHT SIDE 3" [76.2 mm]
LEFT SIDE 0" [0 mm]
TOP 1" [25.4 mm]
JOB NAME MODEL NO.
CONTRACTOR OUTDOOR UNIT MODEL NO.
ENGINEER LOCATION
SUBMITTED FOR APPROVAL RECORD ORDER NO.
DATE