Technical data

HEAT PUMP AND TANK ASSEMBLY

4. Mains Power Connection: Connect the mains power supply wiring to the

terminal block and earth connection inside of the lower front cover.

 Secure the conduit to the side of the storage tank with a saddle

clamp.

The saddle clamp must be positioned over the pilot holes provided,

otherwise the conduit will interfere with the heat pump module

installation.

Refer to “Connections – Electrical” on page 26.

Note: The power supply to the water heater must not be switched on until

the installation is complete, the water heater is filled with water and a

satisfactory megger reading is obtained.

Step 4

Connect wiring and secure conduit with saddle clamp