Use & Care Manual

HORIZONTAL
FILTERS
PUMP
CONNECTIONS
4
FILTER MAINTENANCE
Have your qualified installer or service
agency instruct you on how to access
your filters for regular maintenance.
TURN OFF ELECTRICAL POWER TO
HYDRONIC AIR HANDLER BEFORE
REMOVING FRONT ACCESS DOOR.
FAILURE TO DO SO CAN RESULT
IN ELECTRICAL SHOCK, SEVERE
PERSONAL INJURY OR DEATH.
Keep air filters clean at all times.
Vacuum dirt from filter, wash with
detergent and water, air dry
thoroughly, and reinstall.
After filters are cleaned and returned to
the hydronic air handler, be sure doors
are properly reinstalled. If you are not
totally sure of this procedure, consult a
qualified installer, service agency or
the gas supplier.
REMOVING FILTERS
HYDRONIC AIR HANDLER - FILTER
IN BOTTOM OR SIDE LOCATION
1. Remove the blower compartment
access door.
2. Disengage the filter retaining rod
and pull filter out.
3. Clean filter and reinstall.
4. Replace the blower compartment
access door.
ROUTINE MAINTENANCE
Routine maintenance to be provided
by a qualified installer, service
agency, or gas supplier ONLY.
LUBRICATION
The blower motor and pump motor are
prelubricated by the manufacturer and,
beyond suggested maintenance, do
not require further attention.
IMPORTANT: DO NOT attempt to
lubricate the bearings on the blower
motor or pump motor. Addition of
lubricants can reduce the motor life
and void the warranty.
WARNING
!
FIGURE 4
HORIZONTAL FILTERS LOCATION
CM 0410