Specification Sheet

Air
Engineering Features
RHML Series
3
Engineering Features
RHML- Series
■
The most compact unit design available, all standard heat air
handler models only 42
1
/2 to 55
1
/2 inches [1079 to 1409 mm]
high.
■
Attractive pre-painted cabinet exterior.
■
Rugged wall steel cabinet construction, designed for added
strength and versatility.
■
1.0" foil faced insulation mechanically retained in blower
compartment for excellent thermal and sound performance.
■
Four leg blower motor mount.
■
Blower housing with controls, motor and blower. Slide out
design for service and maintenance convenience.
■
Traditional open wire element design for heat applications.
■
Field convertible for vertical downflow, horizontal left hand or
right hand air supply.
■
3 combustible floor base accessories fit all model sizes when
required for downflow installations on combustible floors.
■
Indoor coil design provides low air side pressure drop, high
performance and extremely compact size.
[ ] Designates Metric Conversions
■
Expansion valve on indoor coil provides for operation with air
conditioning or heat pump using the same coil.
■
Coils are constructed of aluminum fins bonded to internally
grooved copper tubing.
■
Molded polymer corrosion resistant condensate drain pan is
provided on all indoor coils.
■
Supply duct flanges provided as standard on air handler
cabinet.
■
Provisions for field electrical, connections available from either
side or top of the air handler cabinet.
■
Connection point for high voltage wiring is inside the air han-
dler cabinet. Low voltage connection is made on the outside
of the air handler cabinet.
■
Concentric knockouts are provided for power connection to
cabinet. Installer may pull desired hole size up to 2 inches
[51 mm] for 1
1
/2 inch [38 mm] conduit.
■
Front refrigerant and drain connections.