Specification Sheet

Air
Engineering Features
RH1V/RH2V Series
3
Engineering Features
RH1V/RH2V- Series
• Quiet, efficient ECM motor technology providing nominal
airflow up to 1.0 inch [25 kPa] of external static pressure.
• Interface board with dip switches conveniently located in the
blower compartment allows for precise, field selectable air-
flow to meet the requirements of particular applications.
• Selectable continuous fan “on” options.
• The most compact unit design available.
• Attractive pre-painted cabinet exterior.
• Rugged steel cabinet construction, designed for added
strength and versatility.
• 1.0" foil faced insulation mechanically retained in blower
compartment.
• Four leg rubber insulated motor mount.
• Field-installed auxiliary heater kit includes circuit breakers
that meet UL and cUL requirements as a service disconnect
switch.
• Blower housing with integrated controls, motor and blower.
Slide out design for service and maintenance convenience.
• Field convertible for vertical upflow, vertical downflow, hori-
zontal left hand or right hand air supply.
• Combustible floor base accessory available when required for
downflow installations on combustible floors.
• Indoor coil design provides low air side pressure drop, high
performance and extremely compact size. All coils come with
PVC condensate elbow standard.
• Coils are constructed of aluminum fins bonded to internally
grooved aluminum tubing.
• Coils are tested at the factory with an extensive refrigerant
leak check.
• Coils have copper sweat refrigerant connections.
• Coils utilize chatleff metering device connections.
• Molded polymer corrosion resistant condensate drain pan is
provided on all indoor coils.
• Supply duct flanges provided as standard on air handler
cabinet.
• Provisions for field electrical connections available from either
side or top of the air handler cabinet.
• Connection point for high voltage wiring is inside the air han-
dler cabinet. Low voltage connection is made on the outside
of the air handler cabinet.
• Concentric knockouts are provided for power connection to
cabinet. Installer may pull desired hole size up to 2 inches
[51 mm] for 1
1
/2 inch [38 mm] conduit.
• Front refrigerant and drain connections.
[ ] Designates Metric Conversions