Instructions / Assembly
54
Use Instructions
Maximum water temperature occurs while the
water heater burner is ON. To determine the water
temperature:
Turn on the hot water faucet and place a
thermometer in the water stream.
NOTICE:
Water temperature at the faucet may vary depending on the
season and the length of pipe from the water heater.
The display control temperature range is between
100°F (38°C) and 140°F (60°C). To adjust the
temperature to a desired setting, press the UP or
DOWN adjustment button on the face of the remote
control. The new temperature set point will show on
the LED display.
NOTICE:
The temperature set point by default cannot be increase
above 120°F (49°C).
To achieve temperatures above 120°F (49°C), refer page 56
in this Use & Care manual.
The water heater may not operate with a small
water flow. Increase the water flow and recheck. If
it still does not operate with the hot water faucet
completely open, increase the temperature setting
on the water heater.
Water Heater Facts
DANGER:
Water temperatures above 125°F (52°C) will result in
death and/or severe burns from scalding.
• The hottest temperature water will be at the faucet
closest to the water heater.
• Always remember to test the water temperature with
your hand before use.
• Always supervise young children or others who are
incapacitated.
• The water heater is equipped with a device that will
shut off the gas supply to the burner if the water heater
exceeds normal operating temperatures.
• Any water heater that has been subjected to fire, flood,
physical damage, or been under water should be turned
off at the manual gas shut-off valve and not used until
it has been checked by qualified service personnel.
!
PRIORITY
In-Use Indicator
(Lit during operation)
Priority
Indicator
Power On/Off
Indicator
Temperature
Adjustment
Buttons
Temperature
Adjustment
Buttons
WiFi
Button
Priority
Indicator
Power On/Off
Indicator
In-Use Indicator
Lit during operation
Alarm/ Error
Indicator
WiFi Signal
Indicator
Power On/Off
Button
LED
Temperature
and Error Code
Display
LED Temperature
and Error Code
Display
Power On/Off
Button
(WiFi model only)
LED DISPLAY LED WiFi DISPLAY
USING YOUR WATER HEATER