Specification

PRINTED IN U.S.A. 10/16 WP FORM NO. RR102CE-5 Rev. 11
4
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
Rheem Water Heating • 101 Bell Road
Montgomery, Alabama 36117-4305 • www.rheem.com
Rheem Canada Ltd./Ltée • 125 Edgeware Road, Unit 1
Brampton, Ontario L6Y 0P5 • www.rheem.com
Water
INTEGRATED HOME COMFORT
Commercial Electric
PowerPack ASME Water Heaters
I N TEGR ATED AIR & WATER
INTEGRATED HOME COMFORT
Recommended Specifications
(for trade reference only)
Water heater(s) shall be model _________________________,
manufactured by Rheem, having electrical input of
__________ kW and a recovery rate of _____________ GPH
at a 100°F temperature rise. Water heater(s) shall have a
storage capacity of ___________ gallons. Water heater(s)
shall have the UL seal of certification and be factory equipped
with an CSA/ASME rated temperature and pressure relief
valve. Water heater(s) shall be constructed in accordance with
the requirements of the ASME Boiler and Pressure Vessel
Code, Section IV Part HLW. Tank(s) shall have a coating of
high temperature porcelain enamel and furnished with two
(2) magnesium anode rods rigidly supported. Water heater(s)
shall meet or exceed the standby loss requirements of
ASHRAE. Tank(s) shall have a working pressure of 160 psi,
and shall be completely assembled. Water heater(s) shall
be approved-listed and constructed in accordance with UL
Sanitation (NSF5). Water heater(s) shall be equipped with
Lifeguard “screw-in” type elements featuring a stainless steel
outer sheath of Incoloy 840 material. Tank shall be insulated
with 2-1/2" of rigid polyurethane foam insulation. Water
heater(s) shall be constructed with a System Sentinel element
diagnostic panel utilizing light emitting diodes. Each LED
will correspond to the number and location of the heating
elements and monitor their on-off function. Water heater(s)
shall be provided with internal power circuit fusing, control
circuit fusing, magnetic contactors, 120 volt control circuit
transformer and immersion thermostat(s) with manual reset
high limit control. 3/4" inlet and outlet water connections shall
be provided. Water heater(s) shall be covered by a three year
limited warranty against tank leaks.