Submittal Sheet
FEATURES FOR (-)PPL/(-)PNL REMOTE HEAT PUMPS
1
1
/
2 TO 5 NOMINAL TONS [5.28 TO 17.58 kW]
FIELD INSTALLED ACCESSORIES
SPECIAL NOTES ON EQUIPMENT:
• Scroll Compressor
• Copper Tube/Aluminum Fin Coils
• Powder painted louvered steel cabinet protects
the coil from damage
• Internal Check Valve
• Enhanced Compressor Protection
((-)PPL/(-)PNL- *AZ Models Only)
• Manual Reset High Pressure Control
• Drawn Painted Base Pan
• Non-Cycling Reversing Valve
• Hot Gas Muffler
• Bi-Directional Filter Drier (shipped – not installed)
(Standard on (-)PPL/(-)PNL- *AZ Models)
• Service Valves
• TEV Refrigerant Metering
• Demand Defrost Control
• All refrigerant connections are on the exterior of
the unit, located close to the ground for neat
appearing installations
• Coil design permits compressor operation with the
access panel removed
• Control box is fully accessible in the upper part of
the cabinet, just under the access panel
• Power and control wiring are kept separate
• Certified and rated under ARI Standard 240
• U.L. listed
• Factory run tested prior to shipment
• Factory limited warranty as follows:
Condenser Coil leaks caused by
factory defects ................................Five (5) Years
Compressor
JAZ ................................................Ten (10) Years
CAZ, DAZ, YAZ ..............................Five (5) Years
Any Other Part
JAZ..................................................Five (5) Years
CAZ, DAZ, YAZ ................................One (1) Year
Low Ambient Control ......................................
Outdoor Thermostats ......................................
Heat Pump Monitor ........................................
Thermostats and Subbases ............................
Compressor Time Delay Control ......................
Blower Time Delay Control ..............................
Fossil Fuel Kit ................................................
Enhanced Compressor Protection Kit (R-410A)....
Before proceeding with installation, refer
to installation instructions packaged
with each model, as well as complying
with all Federal, State, Provincial, and
Local codes, regulations, and practices.
Rheem Sales Company, Inc.
P.O. Box 17010, Fort Smith, AR 72917
“In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.”
PRINTED IN U.S.A. 1-09 DC FORM NO. X33-1236 REV. 3
Supersedes Form No. X33-1236 Rev. 2



