Specification Sheet

Air
Model Features
RPNL Series
3
All controls and compressor are accessible
for servicing by removal of the service panel.
Drawn Painted Base Pan.
Model Features
RPNL- Series Heat Pump Outdoor Unit
1. Scroll compressor is hermetically sealed and incorporates internal
high temperature motor overload protection, and durable insulation
on the motor windings. It is externally mounted on rubber grommets
to reduce vibration and noise.
2. Copper Tube/Aluminum Fin Coils—Both indoor and outdoor coils.
3. Strong, Attractive Cabinet—Constructed of powder painted steel.
Louvered design protects the coil from damage.
4. Internal Check Valve—Provides for more quiet refrigerant metering.
5. Enhanced Compressor Protection—Features an enhanced defrost
control, auto-reset high pressure control, and auto-reset low
pressure control to provide compressor protection under abnormally
high head pressure conditions (outdoor fan failure, restriction, dirty
coil, etc.) or abnormally low suction pressure conditions (restrictions,
TEV failure, loss of charge, indoor blower failure, etc.) while eliminat-
ing nuisance tripping sometimes experienced with conventional
control systems.
6. Drawn Painted Base Pan—For extra corrosion resistance and
sound reduction.
7. Demand Defrost Control—Provides complete defrost when defrost
is required.
8. Non-Cycling Reversing Valve—Eliminates discharge noises on each
heating cycle.
9. Hot Gas Muffler—Reduces noise in heating cycle.
10. Bi-Directional Filter Drier—Standard on all models (shipped –
not installed).
11. Service valves are standard on all models.
12. Refrigerant Metering—TEV accurately meter refrigerant into indoor
and outdoor coils.
13. The RPNL- has a 10 year limited compressor warranty.
14. All refrigerant connections are on the exterior of the unit, located
close to the ground for neat appearing installations.
15. Coil design permits compressor operation with the access panel
removed.
16. Control box is fully accessible in the upper part of the cabinet, just
under the access panel.
17. Power and control wiring are kept separate.
18. Every unit is factory charged and tested.