Operating instructions

TEMPERATURE CONTROL – DELUXE

TEMPERATURE SETTINGS – DELUXE CONTROLLERS

The temperature settings of each type of Deluxe controller are:

• Bathroom1 & 2 Deluxe 37°C to 48°C* (in 1°C increments), 50°C

• Kitchen Deluxe 37°C to 48°C* (in 1°C increments), 50°C**, 55°C***, 60°C

* limited to 48°C when set to Bath Fill mode on 884 and 886 series model.

** limited to 50°C on an 886 series model.

*** NZ – limited to 55°C.

Temperature settings

37 38 39 40 41 42 43 44 45 46 47 48 50 55 60

warm average hot shower hot very hot

The installation of a Bathroom Deluxe controller(s) only (i.e. no Kitchen Deluxe controller) limits the

temperature setting of the water heater to a maximum of:

• 884 series 50°C

• 886 series 50°C

regardless of the preset outlet temperature setting of the water heater.

The installation of a Kitchen Deluxe controller will allow a maximum temperature setting of:

• 884 series 60°C – AU 55°C – NZ

• 886 series 50°C

regardless of the preset outlet temperature setting of the water heater.

If a Deluxe controller(s) is not installed, the water heater defaults to the preset outlet temperature setting.

This may be up to:

• 884 series 75°C

• 886 series 50°C

Refer to “How Hot Should The Water Be?” on page 5.

On a building fitted with a temperature limiting device such as a tempering valve and where an 884 series

water heater is installed without a separate untempered hot water line to the kitchen, laundry or other non-

ablution area, although the Kitchen Deluxe controller will be able to display temperatures above 50°C and

the water leaving the water heater will be at the set temperature, the maximum water temperature which can

be delivered to the hot water outlets in these locations is determined by the temperature setting of the

temperature limiting device. This is usually 50°C.

On a building fitted with a temperature limiting device set to 50°C, enable the delivery of water temperatures

above 50°C to the kitchen, laundry or other non-ablution area, separate untempered pipe work must be

installed from the water heater to the hot water outlets in these locations.