User Manual

TEMPERATURE CONTROL – DELUXE
37
5. Close the front panel on the Deluxe controller.
6. Turn on the Bath Fill function
 Press the bath fill ( ) button.
On all Deluxe controllers:
 The bath fill operating light will glow.
 The bath fill temperature setting will appear on
the temperature display panel.
 The bath fill water volume will appear on the
bath fill water volume display panel.
 The bath fill indicator light will glow.
7. Open the hot tap.
The operating light will glow on all Deluxe controllers.
Measurement of the water flow at the water heater will
commence when the hot tap is opened.
When the set volume of water has passed through the
water heater:
 Water flow from the hot tap will cease.
 The operating light will go out.
 The bath fill water volume display panel will show
0 litres.
 The temperature display will go blank.
 The bath fill operating light will commence to flash
 The voice prompt will sound;
“the bath is ready, please turn off the hot water tap
and press the bath fill ( ) button to finish”
8. Close the hot tap.
9. Turn off the Bath Fill function
 Press the bath fill ( ) button.
The bath fill operating light and bath fill indicator light
will go out.
The bath fill water volume display will go blank.
Note: If the hot tap has not been turned off, the voice
prompt will sound;
“please ensure the bath hot water tap is turned off”
X 10L
88
°C
X 10L
88
°C
X 10L
88
°C
Rheem
°C
BATH (l)
BATH (l)
°C
120
40
“please set bath water volume
and bath temperature, then
open the hot water tap”
BATH (l)
°C
120
40
“the bath is ready,
please turn off the hot water tap
and press the
bath fill (
) button to finish”
BATH (l)
°C
0
BATH (l)
°C
0
°C
BATH (l)
“please ensure the bath hot
water tap is turned off”