Technical data

INSTALLATION
22
SADDLING - PIPE WORK
To prevent damage to the cylinder when attaching pipe clips or saddles to the water heater jacket, we
recommend the use of self-drilling screws with a maximum length of 13 mm. Should pre drilling be required,
extreme caution must be observed when penetrating the jacket of the water heater.
Note: If the cylinder is damaged as a result of attaching pipe clips or saddles to the jacket, any
resultant faults will not be covered by the Rheem warranty.
TYPICAL INSTALLATON – OUTDOOR LOCATION
TYPICAL INSTALLATION
HEAT PUMP WATER HEATER - 325L