Technical data

COMMISSIONING

TO FILL AND TURN ON THE WATER HEATER

The power supply to the water heater must not be switched on until the

ter heater is filled with water and a satisfactory megger reading is

obtained.

• Open all of the hot water taps in the house (don’t forget the shower).

• Open the cold water isolation valve fully on the cold water line to the water

heater.

Air will be forced out of the taps.

• Close each tap as water flows freely from it.

• Check the pipe work for leaks.

• Plug in the power supply cord at the power outlet (power supply cord model

only).

• Switch on the electrical supply at the isolating switch to the water heater.

Explain to the householder or a responsible officer the functions and operation

of the water heater. Upon completion of the installation

and commissioning of

the water heater, leave this guide with the householder or a responsible officer.

TO TURN OFF THE WATER HEATER

If it is necessary to turn off the water heater on completion of the installation,

such as on a

building site or

where the premises is vacant, then;

• Switch off the electrical supply at the isolating switch to the water heater.

• Unplug the power supply cord from the power outlet (power supply cord

model only).

• Close the cold water isolation valve at the inlet to the water heater.