Instructions / Assembly

HEAT TRAP FITTINGS

Designed for more economical operation of residential water heaters.

Easy to install – equally effective on gas or electric water heaters. Reduces convective heat loss in the piping during

standby. Dielectric fitting shields against galvanic corrosion. Both fittings are electro zinc plated and polypropylene

lined. New design gives quiet operation.

CATCH PAN KIT

Available in 6 sizes to help protect any installation area from possible water

damage. Each 2" deep drain pan is manufactured of aluminum and fitted with a

1" drain outlet. Provides that extra level of “protection assurance” that many

homeowners and apartment dwellers are looking for. Available in 14", 16", 19",

22", 24", and 26

⁄2" diameters. Our specially designed, tapered side wall allows

for “one-inside-the-other” stacking and minimal storage area. Available with side

or bottom drain outlet.

Rheem

and Ruud

Water Heater Accessories

…for fast, economical installation and operation.

Rheem or Ruud water heater accessory kits for easier, quicker

and more economical water heater installation. These custom-

made Rheem or Ruud accessories can help you and your

customers meet local code requirements.

WALL MOUNTING KIT

For Point-of-Use Electric Water Heaters.

This wall mounting kit for point-of-use electric water heater installations provides an easy

way to mount the unit off the floor, out of the way for more usable floor space in a small

area. It’s been designed for use with 6, 10, 15, and 20 gallon models (AS-36111-A) and

all walls with 16" stud centers. All necessary parts are included in this easy to install,

time-and-money saving kit.

STAND KIT FOR GAS WATER HEATERS

For 30, 40, and 50 gallon gas models. The stand kit is an easy, economical way to meet

National Fuel Gas Code and local code requirements to raise a gas water heater 18".

Can be pre-assembled for one man, on-the-job installation. More economical than a

carpenter-built stand. One unit fits 30, 40, and 50 gallon tall models and 30 and 40

gallon stubby models. (AS-29061A)

Catch pan must conform to local codes.

FaxBack # 2203

PAGE 1
FaxBack # 2203 ® ® Rheem and Ruud Water Heater Accessories …for fast, economical installation and operation. Rheem or Ruud water heater accessory kits for easier, quicker and more economical water heater installation. These custommade Rheem or Ruud accessories can help you and your customers meet local code requirements. ® CATCH PAN KIT Available in 6 sizes to help protect any installation area from possible water damage.
PAGE 2
Kit Contents and Installation Instructions INSTALLATION INSTRUCTIONS— WALL MOUNTING KIT 1. Locate wall studs in the area where water heater is to be mounted. Wall support brackets are designed for 16" wall stud centers. Refer to Figure 1. 2. Determine the desired height of the water heater above the floor. Position one wall support bracket. ➀, with flange UP at the determined bottom point of the water heater. Level the bracket and fasten it securely to the wall studs with four lag bolts 1 ⁄4" x 21⁄2" ➄. 3.