Instructions / Assembly

57
Remote Control Selection and Location
WARNING:
Field wiring connections and electrical grounding
must comply with local codes or, in the absence of
local codes, with the latest edition of the National
Electrical Code, ANSI/NFPA 70, in the U.S., or
Canadian Electrical Code, CAN/CSA C22.1, Part 1, in
Canada.
NOTICE:
The provided remote control will allow maximum
temperature settings of 120°F (49°C). Temperatures
up to 140°F (60°C) for residential applications and up
to 185°F (85°C) for commercial applications* can be
achieved with the MAIN (UMC-117) remote control.
Only qualified service personnel should perform this
adjustment.
• An optional cable (EZ Link Cable
TM
)
can be purchased separately
to manifold two water heaters
together�
• DO NOT attempt to disassemble
a remote control� All controls are
sealed and calibrated for accurate
water heater control and operation�
One remote control is provided
with the water heater� Additional remote controls may
be purchased separately� The available remote controls
are listed in the following chart� Up to three remote
controls can be used with the water heater� No other
manufacturer’s controls are suitable for use with this
water heater�
Review the following considerations before determining
the location of the remote control(s):
• DO NOT install any remote control
outdoors or where it can come in contact
with water�
• Avoid installing the remote control in the
following areas and/or conditions:
– area exposed to heat�
– area exposed to steam�
– area exposed to oil�
– area exposed to direct sunlight�
– areas near stored or used
flammable products�
• Place remote control out of children’s reach�
• The remote control should be installed in a convenient
location (e�g�, kitchen, laundry room, utility room, or
directly next to the water heater)�
• The maximum distance between the water heater and
the remote control installation location is limited to 195
ft� (59 m) of wire�
Remote Control
Model Number
Remote Control
Description
Temperature
Set Point Range Availability
UMC-117 MAIN
100°F–120°F (38°C–49°C) Factory Default
85°F (29°C)
125°F–140°F (52°C–60°C)
Qualified Technician
Adjustment for Residential Products
85°F (29°C)
125°F–185°F (52°C–85°C)
Qualified Technician
Adjustment for Commercial Products*
USC1-117
BATH 1
100°F–120°F (38°C–49°C) Optional (Sold Separately)
85°F (29°C) Qualified Technician Adjustment
USC2-117 BATH 2
100°F–120°F (38°C–49°C) Optional (Sold Separately)
85°F (29°C) Qualified Technician Adjustment
MIC-6 or MIC-185**
Manifold System
Manifold System Optional (Sold Separately)
*A commercial conversion kit can be purchased to achieve temperatures up to 185°F (85°C)�
** When a manifold system is installed, the main remote control connected to the manifold controller (MIC-6 or MIC-185)
has priority over the remote controls connected to the water heater�
INSTALLATION INSTRUCTIONS
Electrical