User`s manual

2.Hardware Orientation
VSP 1314 Front Panel
VSP 1314 Use   29
Detail please refer to How to select switching effect.
PIP1/PIP2：PIP mode multiplexing button；
Press button and light up green,that means is1/2 mode;layer 1 above
layer2；
Press button and light up red,that means is 2/1 mode;layer 2 above layer1
LCD showss as following:
Detail please refer to How to set picture in picture.
SAVE/LOAD：SAVE and LOAD muitiplexing button;
Press button and light up green to enter to Save mode,at the same time
CV1/1, CV2/2, USB1/3, DVI1/4, VGA1/5, CV3/6, CV4/7, USB2/8, DVI2/9,
VGA 2/10 all of them light up green ,The figure :1，2，3，4，5，6，7，8，
9，10,down of the button also light up green,It means you can press
arbitrary button to save.And the LCD panel will show Save Sucess after
finish saving.And all the button will recover to its original state.
LCD showss as following:
Detail please refer to How to save parameter.
Press button and light up red to enter to LOAD mode,at the same time
CV1/1, CV2/2, USB1/3, DVI1/4, VGA1/5, CV3/6, CV4/7, USB2/8, DVI2/9,
VGA 2/10 all of them light up red ,the figure of 1，2，3，4，5，6，7，8，
9，10under button is load save1~10，press arbitrary button1~10 to load
PIP A/B
Save:
Press<1~10>to Save