User Manual

厦门视诚科技有限公司 地址：厦门市火炬高新区创业园伟业楼 S601
网址：www.rgblink.com 电话：[phone] 传真：[phone]
11
Chapter 3 Use Your Product
3.1 Browser Login and Track Setup Process
3.1.1 Connecting Mode
Direct connection: Connect the camera via network cable to external Internet access of the PC
Internet connection mode: Connect the camera to Internet by Router or Switch and user can log in the device by
browser.
Note: Please do not put the power and network cable in places where can be easily touched to prevent video quality
lowered by unstable signal transmission due to poor contact of cables.
The computer must have the network segment where the camera IP address belong to. The device will not be
accessible if without the segment. I.E. The camera default IP address is 192.168.5.163, then segment 5 must be
added in the computer.
Specific steps are as below:
Firstly open the window of Local Area Connection Properties on computer, select the “Internet protocol version
4(TCP/IPv4)” as shown by picture on the left. Double click or click the property “Internet” protocol version 4
(TCP/IPv4)to enter into the Internet Protocol Version 4(TCP/IPv4) Properties window, select “Advanced” to enter
into the Advanced TCP/IP Setting and add IP and subnet mask in the IP browser as picture shown below. Click the
“Confirm” to finish the adding of IP segment. User can add the corresponding network segment according to the
revised IP address of the camera.
Note: The IP address to be added cannot be same with that of other computers or devices. The existence of this IP
address needs to be verified before adding.
To verify whether the network segment has been successfully added, click the “Start” and select “Operation” to
input cmd, then click OK and open DOS command window, type ping 192.168.5.26, press Enter key to display
information shown below, which means network segment adding is succeeded.
User can also to verify network connection as steps above mentioned after the finish of camera self-check. If IP is
default, open DOS command window and input 192.168.5.163, then press Enter key, It will show the message as
below, which means network connection is normal.