User Manual

Chapter 2: Installing Your Product
X
2 User Manual
12
Chapter 2 Install Your Product
2.1 Plug in Signals
Connect signals to the product (ensure all devices are powered off first). Tighten connector
screws/locks where provided.
For connector protection and for additional cable support this product is fitted with protection
frames on either side of the device. For cable support use cable ties to attached to the protection
frames to avoid stress on signal connectors.
2.2 Plug in Main Power
Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
2.3 Turn on Your Product
The device will enter to the boot interface, and OLED display will show as below, completing
initialization before loading last settings and input/output configuration.
On delivery, the output format is defaulted to 1920×1080×6
VENUS SERIES X2
[>> ]