User Manual

mini-pro User Manual
39
Logo Overlay
If it is your first time to use Logo Over lay, please connect mini-pro to your computer, and make
sure that IP address of both are in the same network segment.
2
4
3
2. Click “ColorPicker” and select color you want to
filter in the LOGO picture,and current color can be
seen below,and then turn on”Transparent Switch”,the
filtered color will disappear in the LOGO picture.
3.
1
3. After IP address setting,turn on “Enable” and
you can control PTZ camera.
1. Select a picture as the Logo.
3. Click “Logo Generated”,”upgrading”will be seen
in the TFT screen of mini-pro,and the Logo picture
will be imported in.
4. Turn on”On-Off”,and slide to
set “X” and “Y” position. Click Set and confirm.
3