User Manual

25
/25
Fader Correction: Shown Fader Correction steps.
Key Board Test:
LED Light Test select “On”, LED light for each key on front panel will be lit one by one, and KEY Value
shown “MENU”.
LED Light Test select “Off”, LED light for all keys will be off, and KEY Value shown “MENU”.
PTZ Control
M1 V1.56 and later version began supporting PTZ camera control. Specific operations are as follows:
1. M1 and PTZ camera connection:
(1) Network Communication: M1 is directly connected to the network port of PTZ camera through the network
cable, or M1 is connected to the camera in the same LAN.M1 can control up to 7 cameras at the same time.
To modify the camera IP for the first time, the old and new IP should be modified at the same time;
(2) Input signal: THE PTZ camera SDI/HDMI input is connected to the M1 HDMI/SDI input port as the signal
source.
2. Enter < system Settings > and click the camera icon
Click the Settings menu to enter the interface of M1 Camera IP Settings.
Note: IP Settings can only be modified on M1 using the PTZ camera specified by RGBlink.
Turn on the IP setting switch: "valid" is ON,
Old IP address: Input the current IP address of the camera.
New IP address: Input the actual new IP address according to the actual demand.
Note: M1 IP address and PTZ camera need to be in a network segment.
Set the camera IP address and click . After setting successfully, the M1 interface will prompt "Camera
setting is successful".