Quadra User's Guide
Table Of Contents
- Table of Contents
- Introduction
- Installation and Setup
- Operations
- In This Chapter
- Introduction to Operations
- Setting Output Format
- Testing Outputs
- Selecting an Input Source
- Enabling and Disabling Outputs
- Understanding Auto Sync
- Cropping an Image
- Zooming an Image
- Panning an Image
- Sizing the Output Image
- Using Position
- Adjusting Brightness and Contrast
- Adjusting Hue and Saturation
- Adjusting Sharpness
- Creating a Background
- Creating a 2x2 Monitor Wall
- Command Line Interface
- Image Concepts
- Communications Setup
- Connector Types
- Firmware Upgrades and Troubleshooting
- Technical Specifications
350-7951 Quadra User’s Guide 82
A
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMAGE CONCEPTS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IN THIS APPENDIX
This appendix discusses the basics of image size and position, beginning with
the concepts of source and destination rectangles. In addition to the ability to
size and position an input, users can assign different input sources and
manipulate them in various creative ways. These and other topics are discussed
in this chapter:
• Image Rectangles
• Source Rectangle
• Destination Rectangle
• Aspect Ratio
• Positioning and Clipping