Quadra User's Guide
Table Of Contents
- Table of Contents
- Introduction
- Installation and Setup
- Operations
- In This Chapter
- Introduction to Operations
- Setting Output Format
- Testing Outputs
- Selecting an Input Source
- Enabling and Disabling Outputs
- Understanding Auto Sync
- Cropping an Image
- Zooming an Image
- Panning an Image
- Sizing the Output Image
- Using Position
- Adjusting Brightness and Contrast
- Adjusting Hue and Saturation
- Adjusting Sharpness
- Creating a Background
- Creating a 2x2 Monitor Wall
- Command Line Interface
- Image Concepts
- Communications Setup
- Connector Types
- Firmware Upgrades and Troubleshooting
- Technical Specifications
350-7951 Quadra User’s Guide 8
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION AND SETUP
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IN THIS CHAPTER
This chapter provides instructions for installing and setting up your Quadra
system. The following topics are discussed:
• Standard Supplied Components
• Optional Items
• Rack Mounting
• Front Panel
• Rear Panel
• Installation
• System Control Setup
• System Timing
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
STANDARD SUPPLIED COMPONENTS
The following equipment is included in the Quadra shipping carton:
Table 2-1.
Standard Supplied Components
Item Part Number
Quadra
---
Quadra User Manual (on CD-ROM) 350-7951
Power cord (110 or 220 volt) 520-1188 or 520-0271-1
DVI - VGA Adapter 520-7885