User Manual

Warning!!!
A. The purpose of this device is to cause the ignition of fireworks. Fireworks are explosives and may cause personal injuries
or death to yourself or others, including spectators. You are responsible for the safe and legal use of this device
according to the laws and regulations of your country and/or state / province / district. RFRemotech is not responsible
for illegal or unsafe use of this device. The buyer/user assumes all responsibility and liability in the use of this device and
further agrees, by purchase and/or use of this device, to indemnify and hold harmless RFRemotech against all liability for
injury, loss, or damage direct or consequential arising out of the use of, or inability to use this device.
A.FiringModule
B. If the marked LED Indicator above keeps turned RED but not dim red on whenever
the rod of the 3-Position Switch is at OFF, SYNC-TEST or ARM, don't use the module
any more, the unit will igniters randomly. It is dangerous and may do damage to body!
A1.Parts
1
1
2
3
4
5
6
7
1- forigniters/e-matches.WiringTerminals
Redforanode,blackforcathode.
2- ,OFF/SYNC-TEST/ARM.3-PositionSwitch
3- .UsedforsynchronizationorSYNCButton
deletingsynchronization.
4- ,twocolorsredandgreen.LEDIndicator
5- ,retractileandcanbefolded.Antenna
6- .Encloser
7- .BatteryCover
C. This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an
experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.