User Manual

Use Transmitter A to learn Group Sequence.
Keep pressing button LEARN #4 and don’t release until the 3-Position Switch
#5is shifted from OFF to ARM, GREEN of LEARN/FIRE LED #6 blinks
continuously, the firing module is in the mode Group Sequence Learning.
Keep pressing button LEARN #4 again more than 3 seconds to make GREEN
of LEARN/FIRE LED #6on, and then release button LEARN #4, press one
button of Transmitter A within 3 seconds, LED #6 will blink once and then
goes off, after 8 seconds the LED #6 will blink continuously again, the firing
module will remember the group sequence as the number of the learned
button of Transmitter A.
How to know which group sequence the firing module belongs to
and what the sequence of the module is in the group.
Shift 3-Position Switch #5 from OFF to ARM, press the learned button of the
Transmitter A, GREEN of LEARN/FIRE LED #6 should blink once, it indicates
the code of the button is stored in the module.
Keep pressing button LEARN #4and don’t release until the 3-Position Switch
#5 is shifted from OFF to ARM, GREEN of LEARN/FIRE LED #6 blinks, press
the learned group sequence number button of any Transmitter A, GREEN of
LEARN/FIRE LED #6 turns from blink ing to solid green light, it indicates the
group sequence is remembered by the firing module.
Clear codes of transmitters
Shift 3-Position Switch #5 from OFF to ARM, keep pressing button LEARN #4
for more than 6 seconds, GREEN of LEARN/FIRE LED #6 will be on and don’t
release yet until the LED blinks three times and then goes off, all codes are
cleared.
Warning: Only when no igniter / ematch
is connected, you can learn codes or
clear codes!
E. Three Firing Modes
A firing module must learn codes of
transmitters before the transmitters are able
to fire the module.
When a firing module receives a