User Manual

Users should be aware of the following information or should do some
operation below.
It’s better users clear codes of firing module before make the module learn
transmitters.
Only when a firing module learns codes of transmitters, it can work with the
transmitters.
If Transmitter B or Transmitter C is learned but Transmitter A is not learned,
Transmitter B or Transmitter C will not function.
A firing module can store codes of 1x Group Sequence, 1x Button of
Transmitter A, 1x Transmitter B & 1x Transmitter C. If users learn the same
type of transmitter / button, the code of the former transmitter / button will
be replaced.
Mode 1: Normal Learning
Learn the code of Transmitter A:
Shift 3-Position Switch #5 from OFF to ARM, keep pressing button LEARN #7
more than 3 seconds to make GREEN of LEARN/FIRE LED #8 on, and then
release button LEARN #7, press one button of Transmitter A within 3 seconds,
LED #8 will blink once and then goes off, the button of the Transmitter A is
learned by the firing module successfully.
Learn the code of Transmitter B:
Shift 3-Position Switch #4 from OFF to ARM, keep pressing button LEARN #4
more than 3 seconds to make GREEN of LEARN/FIRE LED #6 on, and then
release button LEARN #4, press any button of Transmitter B within 3 seconds,
LED #6 will blink once and then goes off, the Transmitter B is learned by the
firing module successfully.
Learn the code of Transmitter C:
Shift 3-Position Switch #5 from OFF to ARM, keep pressing button LEARN #4
more than 3 seconds to make GREEN of LEARN/FIRE LED #6 on, and then
release button LEARN #4 press any button except Button Lock/Unlock of
Transmitter C within 3 seconds, LED #6 will blink once and then goes off, the
Transmitter C is learned by the firing module successfully.
Mode 2: Group Sequence Learning
Through Group Sequence Learning, a firing module will have its determinate
group. The group sequence number can be one from 1 to 12.