User Manual

Warning!!!
A. The purpose of this device is to cause the
ignition of fireworks. Fireworks are explosives
and may cause personal injuries or death to
yourself or others, including spectators. You are
responsible for the safe and legal use of this
device according to the laws and regulations of
your country and/or state/province/district.
RFRemotech is not responsible for illegal or
unsafe use of this device. The buyer/user
assumes all responsibility and liability in the use of this
device and further
agrees, by purchase and/or use of this device, to
indemnify and hold
harmless RFRemotech against all liability for injury, loss, or damage direct or
consequential arising out of the use of, or inability to use this device.
B. If RED of LEARN/FIRE LED #3 above keeps turned on though 3-position
switch is OFF, don’t use the module any more, the unit will fire e-match or
igniter randomly. It is dangerous and may do damage to body!
A. Firing Module
Two Working Modes:
1-Test: To check if the connection of
igniter / ematch is in good condition.
See “B.Test” below.
2-Fire: To fire igniter / ematch to
make a firework s show. There are 3
firing modes selectable. See “E.
Three Firing Modes” below.
Specifications:
Model No.: RF1K2
Modulation: FSK 433.92MHz
Type: Learning Code
Cue: 1
Power: 9V battery, available either rechargeable or disposable
Firing Current: >750mA, Max.5A