User Manual

2. Fire
When exterior circuit is tested coherent, shift 3-position switch to ARM, press
a button of Transmitter A or B, RED of LEARN/FIRE LED will blink once, firing
current will be sent out.
Please note, in ARM status, receiver can be re-activated after 5 seconds.
For example:
1x Transmitter A TCL2000-12LN;
1x Transmitter B TCL2000-12LNX;
12x Receiver RF1A2: RX1, RX2, RX3, … , RX12.
Firstly have RX3 learn Button 3 of Transmitter A, and then have RX3 learn any
button of Transmitter B, they will work like following,
Press Button 0.1 of Transmitter B, RX3 will fire after 0.1x(3-1)=0.2s;
Press Button 0.2 of Transmitter B, RX3 will fire after 0.2x(3-1)=0.4s;
Press Button 0.4 of Transmitter B, RX3 will fire after 0.4x(3-1)=0.8s;
Press Button ALL of Transmitter B, RX3 will fire instantly. Press Button 3 of
Transmitter A, RX will fire instantly, But other buttons of Transmitter A cann’t
activate RX3.
The similar intervals with other buttons of Transmitter B.
The same with other receivers.
Reference
button/cue can fire multiple e-matches simultaneously.
Any other RFRemotech standard learning code transmitters can be used
instead of Transmitter A TCL2000-12LN and TCF100-12LN.
Manufacturer: RFRemotech
E-mail: [e-mail]
Http://www.RFRemotech.com
JUNE, 2016
Any nu
mber of receivers can be programmed to any of the buttons/cues, so a