User Manual

Before Use
Put 6LR61 9V battery into battery enclosure.
Learn Code
Receiver must learn code of transmitter button, so that transmitters will work
with receiver together.
Only when Transmitter A is learned by receivers, Transmitter B can be learned
by the same receivers, otherwise Transmitter B is invalid.
How to Learn Code of Transmitter A:
Shift 3-position switch to ARM or TEST, keep depressing LEARN button more than 3
seconds to have YELLOW of LEARN/FIRE LED on, and then release LEARN
button, press one of transmitter buttons within 3 seconds, LED will blink once
and then be off, the button is learned by the receiver successfully.
How to Learn Code of Transmitter B:
When Transmitter A is learned by receiver successfully, have the receiver
learn any button of Transmitter B according to the same steps as Transmitter
A, Transmitter B will work with the receiver. You don’t need to have all
buttons of Transmitter B learned by the receiver.
Through learning Transmitter A, receivers will learn sequences number.
Through learning Transmitter B, receivers will learn intervals.
How to Clear Code: Shift 3-position switch to ARM or TEST, press LEARN button
and don’t release the button for more than 6 seconds until YELLOW of
LEARN/FIRE LED blinks three times and then goes off, code is cleared.
Warning: Only when no fireworks is connected, you can Learn Code
or Clear Code!
How to Use
1. Test
To check if exterior circuit is coherent.
When an exterior circuit is connected, Shift 3-position switch to TEST, if TEST
LED is on, it indicates the exterior circuit is coherent; If not, it indicates the
exterior circuit is interrupted.