Manualshelf

User's Manual

ManualsBrandsRFNet Technologies ManualsElectronicsWireless LAN 802.11b/g AP & Ethernet Bridge
13141516171819202122
About
This page shows the firmware version and the date at which the firmware was updated.
Factory Default Setting
To set the wireless bridge back to factory default setting, press the reset button for 5sec and
release.
The factory default setting is as follows:
No Item Factory Default
1 User ID (for configuration) admin
2 Password (for configuration) admin
3 Default Static IP address 10.0.0.2
4 Default Subnet Mask 255.0.0.0
5 Default Gateway Address 0.0.0.0
6 WLAN Client Mode Client
7 WDS Disable
8 ESSID Teraoka
9 WEP/WPA Off
10 Radio Power 100%
11 FTP Port 1301
12 Country Default NA
13 Additional Files in Flash Version
14 Firmware Version Version 3.00B0