User Manual

10 PC CONFIGURATION
The Router’s function is to connect multiple PCs to the Internet. In addition to configuring the
Router, the PCs’ IP settings would also need to be configured.
It is easiest to use DHCP client for the PCs. This is also the default whenever you:
a. Install a new Wireless PCMCIA/Cardbus card, or
b. When you plug an Ethernet cable into your PC for the first time.
Fortunately, in default mode, the Router’s DHCP Server is on. This means that when you buy a
new Router and install a new Wireless Card, the IP settings on the PC are already correct!
In the event that you need to troubleshoot the IP settings, the easiest method is:
a. Perform a Hardware Reset to the Router, and
b. Perform a following to configure Automatic IP (DHCP Client) on the PC.
Setting DHCP IP Address
The steps outlined are applicable for Windows PCs. The GUI for Windows 98SE and ME may
look slightly different, but the steps are the same.
1. Connect the PC to the Router. This can be via Ethernet or Wireless. Do not connect
any other networking devices! Do not connect the modem to the PC!
2. Go to Start >> Settings >> Control Panel >> Network and Dial-Up Connections
3. Double-click Local Area Connection.
4. Click on Properties.
Page 37 of 45