User Manual
Table Of Contents
- INTRODUCTION
- PACKAGE CONTENTS
- CONNECTIONS
- LED
- BASIC IP NETWORKING
- GETTING STARTED
- CONFIGURATION WIZARD
- CONFIGURATION MENU
- System Summary > Configuration
- System Summary > Associations
- System Summary > Statistics
- System Summary > Site Scan
- Basic > SNTP Setting
- Basic > LAN Setting
- Basic > WAN Setting
- Basic > MAC CLONE
- Wireless > Basic Setting
- Wireless > Advance Setting
- Wireless > MAC Address Control
- DHCP > DHCP Server
- DHCP > DHCP List
- Port Forward > Virtual Server
- Port Forward > ICMP Forward
- Port Forward > DMZ Setting
- Port Forward > UPnP Setting
- Firewall > MAC Filter
- Firewall > IP Filter
- Miscellaneous > Dynamic DNS
- System Tools > System Log
- System Tools > System Admin
- System Tools > Backup/Restore Settings
- System Tools > Firmware Update
- System Tools > Reboot
- FACTORY RESET
- PC CONFIGURATION
- TECHNICAL SUPPORT
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
The manufacturer declares that APRT-2518G/APRT-2518GS is limited to channel 1~channel 11
by specified firmware controlled in USA.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
To maintain compliance with FCC RF exposure compliance requirements, please avoid direct
contact to the transmitting antenna during transmitting.
Information to User:
The users manual or instruction manual for an intentional or unintentional radiator shall caution
the user that changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Page 2 of 45