User Manual
Table Of Contents
- INTRODUCTION
- PACKAGE CONTENTS
- CONNECTIONS
- LED
- BASIC IP NETWORKING
- GETTING STARTED
- CONFIGURATION WIZARD
- CONFIGURATION MENU
- System Summary > Configuration
- System Summary > Associations
- System Summary > Statistics
- System Summary > Site Scan
- Basic > SNTP Setting
- Basic > LAN Setting
- Basic > WAN Setting
- Basic > MAC CLONE
- Wireless > Basic Setting
- Wireless > Advance Setting
- Wireless > MAC Address Control
- DHCP > DHCP Server
- DHCP > DHCP List
- Port Forward > Virtual Server
- Port Forward > ICMP Forward
- Port Forward > DMZ Setting
- Port Forward > UPnP Setting
- Firewall > MAC Filter
- Firewall > IP Filter
- Miscellaneous > Dynamic DNS
- System Tools > System Log
- System Tools > System Admin
- System Tools > Backup/Restore Settings
- System Tools > Firmware Update
- System Tools > Reboot
- FACTORY RESET
- PC CONFIGURATION
- TECHNICAL SUPPORT
Make sure that APs are located far away from one another to avoid interference.
Interference
Interference happens when 2 APs with the same channels are placed near to one another. The
speed of the network drops and the signal strength fluctuates wildly.
Roaming
Association happens when the SSID, Encryption and MAC Address Control settings are correct
between the AP and client. If 2 APs with these same settings are located in the same area, the
client would choose to associate to the one which gives it a better signal strength. The client
would roam over to the 2nd AP when he moves nearer to it. The client switches AP and
frequency as he does so.
Page 10 of 45