User's Manual

RFNet Wireless LAN Access Point AP-I002

You can view all the commands history you typed in by issuing this command.

9) load

This command is for you to update the firmware. Typing load

alone and then you will get detailed

information of this command’s usage. You must setup a TFTP server prior to update the firmware,

and then copy the new firmware to the TFTP server’s directory. For example, let’s assume that

your TFTP server’s IP address is 155.69.178.128, therefore, your command should be load

155.69.178.128.

10) logoff

This command is used as a quick way to log off the session.

11) show

This command is used to show all the parameters inside this AP-I002. For more information about

the parameters, please type show ?

and then the following figure appears on your screen:

To show the value of a particular parameter, like for example, apname, please type show apname

and the particular name for the AP-I002 in use is quickly displayed on the screen.

12) version

This command is to inform you the version of this AP-I002.

User Manual