User`s guide

SEM910

arp Manipulates the address resolution procedure table. This command is provided

primarily as a debugging tool for setting up networks.

ipaddr is the device IP

address and eaddr is the physical Ethernet address of the device

default Resets SEM configuration parameters to factory default settings. This command

does not reset the radio parameters. Use the

radio default command to reset the

radio parameters. See the section on Radio Commands for details.

echo Toggles the user screen mode to echo characters typed by the user. Default is on. If

echo is turned off, characters typed will not be displayed on the screen unless echoed

by the terminal program.

ip Sets the IP address of the SEM. The default IP address is 0.0.0.0. When specified,

netmask sets the netmask number. The default netmask is 255.255.255.0.

ping Sends inquiry packets to TCP/IP host specified in

<ipaddr> and displays the amount

of time that elapsed before a response was received. Continuously sends requests

until a key is pressed.

reset Resets the SEM and loads saved parameters into active memory. Also causes the

SEM to reinitialize which can take 30 seconds. If reset is issued before the save

command, the new parameters are lost and the last saved parameters are used.

route Displays and manipulates gateway IP addresses to route IP traffic off the subnet.

Default sets the first gateway attempted.

save Saves changed parameters in non-volatile memory to be loaded on power up. Must

be issued before the reset command or cycling power to have changed parameters

take effect. (An exception is the

sys outmax command which becomes active

immediately after it is entered.)

sys

mode displays whether SEM is configured as a Master or Slave. Setting Master or

Slave mode is performed using the bridge command. Refer to the section Bridge

Commands for details.

outmax controls how data is presented to the SEM radio. This command should not

be used without advice from Cirronet Technical Support.

version Displays the SEM firmware version.