User`s guide

HN-591

Set the Frequency Operating Range

by clicking on the drop-down menu

and making a selection. ¹

Set Radio Power Setting up by

clicking on a selection. ²

Note: This list will change depending

on which radio is being used.

Set Maximum Number of Remotes

from1 to 62.

Set Redundant Transmit by

selecting either ARQ enabled or ARQ

disabled.

Choose to have the Banner Display

or not by selecting Banner disabled or

Banner enabled.

Choose the type of Escape Sequence

by selecting Once after reset or

Unlimited times.

¹ The selections in this field will change depending on the frequency band the radio operates in. For 2.4GHz

radios, selecting one of the 802.11b bands in which to operate, the HopNet radio can be used in locations with

802.11b networks without causing interference with those networks. If there are no 802.11b networks present, it

is recommended that the radio be set to operate in the entire band which is the default. For 900MHz radios, there

will only be two bands to select.

² The Radio Power Setting controls how much power is used to transmit data. Unless the HopNet radio operates in

the 2.4GHz band and is being used in the European Union (EU) this setting should be left at the default High

Power. Because of the built-in antenna of the HopNet radio, the 10mW power setting must be used when

operating in an EU country.