User`s guide

HN-591

Roaming Mode

This parameter allows remote radios to link to any base station or only link to specific

base stations.

Protocol Mode

This parameter enables the base station to operate in a multipoint network.

Depending on the user application, more or less acknowledgment may be desired by

the application. Remotes can operate in transparent mode even though the base

station is operating in one of the nontransparent modes. When using a protocol mode,

make sure to count in packet overhead when calculating network performance. Refer

to the section on Protocol Modes for details on each format.

When the radio is linked to another radio, a communications test can be run by

clicking on the Send Data button (shown below) on both radios. The remote radio’s

Transmit Data window (above left) will display the message, “This is a test message

from the Base radio”, which will repeat until the Stop button is pressed (on the base

radio’s HN Wizard main screen). The base radio’s Transmit Data window (above

right) will display the message, “This is a test message from the Remote radio” which

will repeat until the Stop button is pressed (on the remote radio’s HN Wizard main

screen).

Send Data

The Send Data button (shown below) initiates the transmission of data.