User guide

www.RFM.com Technical support +1.678.684.2000 Page 12 of 21
© 2011 by RF Monolithics, Inc. E-mail: [e-mail]
DN-2400E User Guide - 08/05/11
6.2 Getting Started
The Starter Kit contains two Ethernet Bridge units. One unit is labeled “Base” and the second unit is la-
beled “Remote”. These are the default configurations set at the factory. They can be changed as ex-
plained below. The DN-2400E units are powered using the included power supplies. The DN-2400EP
units can be powered either with the included power supplies or a from hosts that implements IEEE
802.3af Mode B Power over Ethernet.
Figure 6.2.1
6.3 Attaching the Antenna
Attach an antenna to each unit by screwing the antenna onto the antenna connector. The supplied anten-
nas are hinged, allowing them to be set vertically with the case mounted either horizontally or vertically as
shown in Figure 6.3.1.
Figure 6.3.1