Specifications

MFC-CB™ Operation and Maintenance Manual
©2001~2007 DH Instruments, a Fluke Company Page 24
When the UNIT DISPLAY is selected on the active device channel, the UNIT
DISPLAY is also used for the other device channel if possible. When changing
device channels, the same unit types are used. If the UNIT DISPLAY setting on
the active device channel was for “electrical unit = flow unit”, the display of the
new channel will be “electrical unit = flow unit”. If a required unit type is not
available (for example there is no flow unit because the current MFC profile is a
factory default profile) the display defaults to the CLEAN DISPLAY.
To go to a DISPLAY other than UNIT, press [DISPLAY] and make a new
DISPLAY choice.
3.2.4.6 <6CLEAN>
 PURPOSE
To activate the CLEAN DISPLAY.
See Section 3.2.4, PRINCIPLE.
 OPERATION
To activate the CLEAN DISPLAY press [DISPLAY] and select <6clean>.
Selecting <6clean> returns to the MAIN run screen with the CLEAN
DISPLAY active.
With the CLEAN DISPLAY active, the MAIN run screen is:
1. Standard MAIN run screen top line.
2. “Clean” second line.
To go to a DISPLAY other than CLEAN, press [DISPLAY] and make a new
DISPLAY choice.
2
5.0000 V 4.9984
D1