Specifications

MFC-CB™ Operation and Maintenance Manual

 OPERATION

To activate the DIF DISPLAY, press [DISPLAY] and select <3dif>. To reach the

DIF DISPLAY, it is required that DEV1 and DEV2 be set in the same unit

of measure. If the DIF DISPLAY is attempted while the unit of measure on the

two device channels is not the same, an error message appears. In this case,

set both channels to the same unit of measure and retry.

With the DIF DISPLAY active, the MAIN run screen is:

1. Standard MAIN screen top line for the active

device channel.

2. Indication of difference calculation formula, the

active device channel is to the right.

3. Difference of the inactive and active device

channel measurements.

While in the DIF DISPLAY, changing the unit of measure causes the display to

revert back to the CLEAN DISPLAY. This can happen by making a unit change

using [UNIT] or by selecting a new MFC profile using [MFC].

To switch the DIF DISPLAY from D2 – D1 to D1 – D2 and vice versa, change the

active channel by pressing [DEV1/2].

To go to a DISPLAY other than DIF, press [DISPLAY] and make a new

DISPLAY choice.

3.2.4.4 <4RATIO>

 PURPOSE

To display the ratio of the measurements of the inactive device channel and the

active device channel.

See Section 3.2.4, PRINCIPLE.

 OPERATION

To activate the RATIO DISPLAY, press [DISPLAY] and select <4ratio>.

To reach the RATIO DISPLAY, it is required that DEV1 and DEV2 be set in the

same unit of measure. If the RATIO DISPLAY is attempted while the unit of

measure on the two device channels is not the same, an error message appears.

In this case, set both channels to the same unit of measure and retry.

100.00 sccm 99.998

0.035 D2-D1