Specifications

December 2008 v
FOCUS System Manual
Introduction
We recommend that before installing and energizing the FOCUS system equipment, you
become acquainted with the information in this manual. Failure to do so may result in
injury to personnel or damage to the equipment and may affect the equipment warranty.
If the FOCUS system is mounted in a cabinet, the cabinet must be bolted to the floor or
otherwise secured before installing the FOCUS chassis to prevent the unit from tipping
over. You may, however, remove or insert the FOCUS printed circuit modules while the
chassis is energized, provided you are properly grounded.
AMETEK does not assume liability arising out of the application or use of any product
or circuit described herein. AMETEK reserves the right to make changes to any products
described herein to improve reliability, function, or design. Specifications and informa-
tion herein are subject to change without notice. All possible contingencies which may
arise during installation, operation, or maintenance and all details and variations of this
equipment are not purported to be covered by these instructions. If you desire further
information regarding a particular type of installation, operation or maintenance of
equipment, please contact your local AMETEK representative.
© Copyright by AMETEK, ALL RIGHTS RESERVED.
AMETEK does not convey any license under its patent rights nor the rights of others.
ESD Warning!
BEFORE HANDLING ANY AND ALL MODULES OR EQUIPMENT FROM
AMETEK, YOU MUST BE PROPERLY GROUNDED, TO PREVENT DAMAGE
FROM STATIC ELECTRICITY .
All semiconductor components can be damaged by the discharge of static electricity.
Be sure to observe all Electrostatic Discharge (ESD) precautions when handling
modules or individual components.