Specifications

Page 27–4
FOCUS System Manual
Figure 27–5. Typical DCU module network.
Service3- Network1- Frame Relay
Network1: Channel: 1) 56k, Service3, 7F
Frame Relay Service: NI, LMI
Endpoint: pulsar, Service 3 DLCI 22
Circuit Table: pulsar 111.222.333.444
255.255.255.252
DHCP Server Enable, Router IP: 11.22.33.44
IP addr. list: “Your Default Gateway”
V
erilink 5370 Configuration:
Interface: Ethernet 10.22.33.44 255.255.255.0
Service 3: Interface: Network
Type: Frame Relay: UNI, LMI Pair: 0
Service 4: Serial1, SCADA (not needed for
lab test), Serial1- RS-232, 38400, Async, 8,
none, 1, RTS Forced True, SCADA- pulsar
Endpoint: pulsar Service 3, DLCI 22
Circuit Table: pulsar 10.20.30.40
255.255.255.252
DHCP Server: Enable, Router IP: 10.22.33.44
IP addr. list: “Your Default Gateway”
7. Check the indicator on the routers.
The NET LED should illuminate, indicating
that there is a clear path between DCU
modules.
27.5 Drawings
The schematic for the DCU Module and interface
is available upon request.
The component location drawings are at the end of
this chapter.
DS1
(T1)
56k
Ethernet
192.2.3.4
192.22.33.44
192.1.2.3
192.20.30.40
FOCUS with DCU Module
SUBSTATION A
SUBSTATION B
FOCUS
FIBER OPTIC COMMUNICATIONS FOR UTILITY SYSTEMS
Te chnologies, Inc.
//
NET
EXIT
SCROLL
SELECT
#1
SERIAL
#2
SERIAL
POWER
WANsuite 5160
VERILINK
WANSUITE 5160
REV. 1.0/3.20
NET
EXIT
SCROLL
SELECT
#1
SERIAL
#2
SERIAL
POWER
WANsuite 5370
VERILINK
WANSUITE 5370
REV. 1.0/3.20
Ethernet
Switch
*
Network
* Or Cross-connect Cable