Specifications

Page 25–2
FOCUS System Manual
been done to rule out invalid test results for
this module
• FCS is up and running (see the FCS online
help facility: FOCUS Configuration
Software > Starting FCS)
25.3.1 Hardware Installation and
Connections
To install the 6NF module and interface, complete
the following steps.
1. Bring the FOCUS chassis “on line”.
Click on the “Online” speed button
.
This uploads to the FCS the current status,
settings, operating statistics, etc., for the
FOCUS chassis — and the 6NF module.
2. Unlock the FOCUS chassis.
If the chassis is locked, execute the “Unlock
Configuration” command on the FCS Setup
menu or click on the “Unlock FOCUS Chassis”
speed button .
This puts the chassis — and the 6NF module
— into a configurable state.
3. Insert the Module into the FOCUS chassis.
Carefully insert the 6NF module into the top
and bottom grooves of an open slot on the
FOCUS chassis. Slide it all the way in until it is
well seated in the slot. Lock it into place using
the black ejector clip on the front of the
module.
When you first insert the module, the red/green
status LED is red. If the module is functional,
the status LED turns green within 20 seconds.
If the module is non-functional, the status LED
stays red, even after 20 seconds have elapsed.
4. Connect the interface module to the FOCUS
chassis.
Attach the appropriate interface module to the
rear of the FOCUS chassis so that it connects to
the module.
Figure 25–2. 64NF Configuration Window.
Figure 25–1. 6NF Interface Module.
RJ-45
6NF
RCV
XMIT