Specifications

Page 15–2
FOCUS System Manual
• The FOCUS Configuration Software (FCS)
has been installed on your computer (see
Chapter 3)
• Acceptance tests for the FOCUS chassis
and all previously installed equipment have
been done to rule out invalid test results for
this module
• FCS is up and running (see the FCS online
help facility: FOCUS Configuration
Software > Starting FCS)
15.3.1 Hardware Installation and
Connections
To install the Contact Transfer (CTR) Module
and interface, complete the following steps.
1. Bring the FOCUS chassis “on line”.
Click on the “Online” speed button
.
This uploads to the FCS the current status,
settings, operating statistics, etc., for the
FOCUS chassis — and the CTR module.
2. Unlock the FOCUS chassis.
If the chassis is locked, execute the “Unlock
Configuration” command on the FCS Setup
menu or click on the “Unlock FOCUS
Chassis” speed button .
This puts the chassis into a configurable state,
allowing you to install the Contact Transfer
Module and interface.
3. Insert the Contact Transfer (CTR) Module
into the FOCUS chassis.
Carefully insert the CTR module into the top
and bottom grooves of any open slot on the
FOCUS chassis. Slide it all the way in until it
is well seated in the slot. Lock it into place
using the black inject/eject lever on the front
of the module.
When you first insert the CTR module, the
red/green status LED is red. If the module is
functional, the status LED turns green within
20 seconds. If the module is non-functional,
the status LED stays red, even after 20
seconds have elapsed.
Figure 15–2.
CTR Interface Module.
4. Connect the CTR interface module to the
FOCUS chassis.
Attach the interface module to the rear of the
FOCUS chassis so that it connects to the CTR
module. It is important to securely attach the
CTR interface to the chassis with the supplied
screws to prevent damage to the electrical
DIN connector.
CTR
OUT
IN
P1P2
1
2
3
4
5
6
7
8
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
16
1
2
3
4
5
6
7
8
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
16