Specifications

Page 14–12
FOCUS System Manual
2. Connect the voltage supply source and
timer “start” to the “local” chassis.
Connect the voltage supply source and the
timer “start” connections to the “key input 1”
positions on the PRI interface for the “local”
chassis, as shown in Figure 14-10.
3. Connect the timer “stop” to the “remote”
chassis.
Connect the timer “stop” connections to the
“trip input 1” positions on the PRI interface
for the “remote” chassis, as shown in Figure
14-11
4. Start the FCS.
Bring up the FOCUS Configuration Software
(FCS), if it is not already running, by clicking
on the FCS program icon .
5. Bring the FOCUS chassis “on line”.
Click on the “Online” speed button
.
This uploads to the FCS the current status,
settings, operating statistics, etc., for the
FOCUS chassis — and the PRI module.
6. Unlock the FOCUS chassis.
If the chassis is locked, execute the “Unlock
Configuration” command on the FCS Setup
menu or click on the “Unlock FOCUS
Chassis” speed button .
This puts the chassis — and the PRI module
— into a configurable state.
Figure 14–11.
Local Terminal Wiring Connections.
Figure 14–12.
Remote Terminal Wiring Connections.