Specifications

Page 12–8
FOCUS System Manual
5. Unlock the FOCUS chassis.
If the chassis is locked, execute the “Unlock
Configuration” command on the FCS Setup
menu or click on the “Unlock FOCUS
Chassis” speed button .
This puts the chassis — and the V2T/V2W
module — into a configurable state.
6. Configure the DS0 channel assignments.
For instructions on setting the DS0 channel
assignments for the chassis’ channel modules,
please refer to the FCS online help facility
(Channel Assignments Map > Making Time
Slot Assignments > To set up the Channel
Assignments Map).
Assign one open DS0 channel, or time slot, on
XCVR-1 to channel A and another to channel
B. Make sure you assign the same DS0
channels, or time slots, to the same module
channels on both modules/chassis.
7. Connect the two telephone sets.
Connect a telephone set to the channel A
connection on the V2W’s interface module on
the rear of each chassis. You can connect to
either the compression-type terminal block or
the RJ-9 jack, as long as you use the connec-
tion for channel A (see Figure 12-3).
8. Check both ends of the circuit.
Lift the receiver from the telephone connected
to one end of the circuit to make sure the
telephone at the other end rings. Make sure
you can communicate in both directions. Then
hang up and repeat this step from the other
end of the circuit.
Repeat Steps 7–8 using channel B.
12.6 Drawings
The schematic for the V2W/V2T Module is
available upon request.
The component location drawings for the modules
and interfaces are at the end of this chapter.