Specifications

viii
Document Overview
Chapter 1 provides a general description of the FOCUS system and its main components
and features. It also lists the specifications for the system and for each system and channel
module.
Chapter 2 describes the system’s application and tells you how to order a FOCUS system.
Chapter 3 provides installation instructions for the system. It also tells you how to install
the FOCUS Configuration Software (FCS).
Chapter 4 tells you how to perform the acceptance tests for your FOCUS common
equipment, as well as the proper testing equipment to use.
Chapter 5 gives you an in depth look at the FOCUS Alternate Path Mode feature,
including configuration, setup, operation, and troubleshooting instructions.
The remaining chapters tell you all about the FOCUS hardware, module by module.
At the end of the manual is a set of appendices for reference.
Additionally the manual’s contents include:
•Description of each module
• The module’s application(s)
• Hardware installation instructions
• Software configuration instructions
•Acceptance Tests
•Technical specifications
•Status indicators
•Component location drawings
• Schematics are available upon request
Trademarks
All terms mentioned in this book that are known to be trademarks or service marks are listed below.
In addition, terms suspected of being trademarks or service marks have been appropriately capital-
ized. AMETEK can not attest to the accuracy of this information. Use of a term in this book should
not be regarded as affecting the validity of any trademark or service mark.
This publication includes fonts and/or images from the Corel Corp. which are protected by copyright
laws of the U.S., Canada and elsewhere. Used under license.
IBM and PC are registered trademarks of the International Business Machines Corporation.
ST is a registered trademark of AT&T