Data Sheet
Table Of Contents
- Features
- Applications
- Description
- Blockdiagram
- Characteristics
- Application Notes
- Integrators Information
- This module is approved for installation into fixed and/or mobile host platforms and must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC/ISED multi-transmitter guidelines. End users must be provided with transmitter operating conditions for satisfying RF Exposure compliance.
- Hereby, RFbeam Microwave GmbH declares that the radio equipment type K-MC4 is in compliance with Directive 2014/53/EU. The declaration of conformity may be consulted at www.rfbeam.ch.
- Outline Dimensions
- Ordering Information
- (includes Mounting Plate Type1)
- Datasheet Revision History
K-MC4 MONOPULSE RADAR TRANSCEIVER Datasheet
FM Characteristics
Frequency modulation allows FSK (Frequency Shift Keying) and FMCW (Frequency Modulation
Continuous Wave) techniques for ranging applications.
For optimal FMCW results, the VCO characteristic should be linearized by the driving software.
Fig. 4: Typical frequency vs. VCO voltage
Pin Configuration
Pin Description Typical Value
1 /Enable GND: module active
2 VCC 5V supply
3 GND 0V supply
4 Q1: Rx1 IF output Q Output from Rx1
5 I1: Rx1 IF output I Output from Rx1
6 VCO in 5V = f
0
(Range 0 ..10V)
7 Q2: Rx2 IF output Q output from Rx2
8 I2: Rx2 IF output I output from Rx2
© RFbeam Microwave GmbH, Schuppisstrasse 7, CH-9016 St. Gallen Page 5/14
f
0