Data Sheet
Table Of Contents
- Features
- Applications
- Description
- Blockdiagram
- Characteristics
- Application Notes
- Integrators Information
- This module is approved for installation into fixed and/or mobile host platforms and must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC/ISED multi-transmitter guidelines. End users must be provided with transmitter operating conditions for satisfying RF Exposure compliance.
- Hereby, RFbeam Microwave GmbH declares that the radio equipment type K-MC4 is in compliance with Directive 2014/53/EU. The declaration of conformity may be consulted at www.rfbeam.ch.
- Outline Dimensions
- Ordering Information
- (includes Mounting Plate Type1)
- Datasheet Revision History
K-MC4 MONOPULSE RADAR TRANSCEIVER Datasheet
Ordering Information
Module Part #: K-MC4 Transceiver
(includes Mounting Plate Type1)
Datasheet Revision History
Version Date Changes
1.0 2010-10-29 initial release
1.1 2011-04-18 Corrected chapter Sensitivity and Maximum Range to S = -134dBc
1.2 2011-05-10 Changed the drawing of the case
1.3 2011-05-26 Case dimensions corrected on page 1, features
2.0 2011-11-15 Chapter Using VCO and IF Outputs adapted to new Hardware starting
with Lot# L1120
2.1 2012-01-17 Gain corrected to 20dB in block diagram
2.2 2015-09-23 Typing Error VCO 12V corrected to 10V in chapter Pin Configuration
2.3 2020-03-05 Added chapter Integrators Information, changed Layout
© RFbeam Microwave GmbH, Schuppisstrasse 7, CH-9016 St. Gallen Page 14/14
RFbeam does not assume any responsibility for µse of any circuitry, method or characteristic described, no circuit patent
licenses are implied and RFbeam reserves the right at any time without notice to change said circuitry and specifications.