Data Sheet

Table Of Contents

K-MC4 MONOPULSE RADAR TRANSCEIVER Datasheet

United States (FCC) and Canada (ISED)

This module has been granted modular approval for fixed and/or mobile applications. The modular

approval allows the end user to integrate the module into a finished product without obtaining

subsequent and separate FCC/ISED approvals for intentional radiation, provided no changes or

modifications are made to the module circuitry. Changes or modifications could void the user’s

authority to operate the equipment. The end user must comply with all of the instructions provided by

the Grantee, which indicate installation and/or operating conditions necessary for compliance. The

finished product is required to comply with all applicable FCC/ISED equipment authorizations

regulations, requirements and equipment functions not associated with the transmitter module portion.

Note

Modification to this product will void the users’ authority to operate this equipment.

Warning

The OEM integrator is responsible for the final compliance of the end product with this integrated

modular approved transmitter module. This includes measurements with the RF module integrated

and activated as defined in KDB 996369 and if applicable appropriate equipment authorizations as

defined in §15.101.

Labelling and user information requirements

If the label of the module is not visible from the outside of the end product, it must include the following

texts on the label of the host product:

FCC: Contains FCC ID: 2ASYV-K-MC4

ISED: Contains IC: 24358-KMC4

In addition to marking the product with the appropriate ID’s, the end product shall bear the following

statement in a conspicuous location on the label or alternatively in the user manual:

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt

RSS standard(s). Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne

doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF Exposure

This module is approved for installation into fixed and/or mobile host platforms and must not be co-

located or operating in conjunction with any other antenna or transmitter except in accordance with

FCC/ISED multi-transmitter guidelines. End users must be provided with transmitter operating

conditions for satisfying RF Exposure compliance.