User's Manual

Integration instructions for host
product manufacturers
According to KDB 996369 D03
© RFbeam Microwave GmbH, Schuppisstrasse 7, 9016. St. Gallen, www.rfbeam.ch Page 1/1
2.2 List of applicable FCC rules
The applicable FCC rules are listed in the section integrators information of the product datasheet:
“This module meets the title 47 of the Code of Federal Regulations, part 15 section 15.249 for
intentional radiators operating in the 24.00 to 24.25 GHz band.“
2.3 Summarize the specific operational use conditions
The product has integrated patch antennas. There are no specific operational use conditions.
2.4 Limited module procedures
The product is granted as a single modular transmitter.
2.5 Trace antenna designs
The product has integrated patch antennas.
2.6 RF exposure considerations
The following is included in the section integrators information of the product datasheet:
“The radiated output power of the device is far below the FCC radio frequency exposure limits.
Nevertheless, the device should be used in such a manner that the potential for human contact during
normal operation is minimized.”
2.7 Antennas
The module has integrated patch antennas.
2.8 Label and compliance information
The following is included in the section integrators information of the product datasheet:
“If the label of the module is not visible from the outside of the end product, it must include the
following texts on the label of the host product:
FCC: Contains FCC ID: 2ASYV-K-LD7
In addition to marking the product with the appropriate ID’s, the end product shall bear the following
statement in a conspicuous location on the label or alternatively in the user manual:
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.”
2.9 Information on test modes and additional testing requirements
The following is included in the section integrators information of the product datasheet:
“Testing for the modular approval has been performed with the 10m range setting for all available
frequency channels which represents the maximum TX emission configuration with the complete used
bandwidth. This setup can easily be used by the customer for certification purposes.”
2.10 Additional testing, Part 15 Subpart B disclaimer
The following warning is included in the section integrators information of the product datasheet:
“The OEM integrator is responsible for the final compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification.”